#1 2nd RAID0 doesnt show up by icedon 16.02.2015 10:09

Hey,

my configuration is the following:
2 x SSD each as single Disk
2 x WD HDD as RAID0
sysProfile
I Need to Transfer my data to a larger disk storage so I bought additional HDDs which will later replace the old RAID0. I configured the two new HDDs as RAID0 using ctrl+i while booting up.
The RAID0 creates without problems but doesnt show up in Windows 8.1. Any suggestions?

Thanks,
Don

#2 RE: 2nd RAID0 doesnt show up by Fernando 16.02.2015 10:15

avatar

Zitat von icedon im Beitrag #1
I Need to Transfer my data to a larger disk storage so I bought additional HDDs which will later replace the old RAID0. I configured the two new HDDs as RAID0 using ctrl+i while booting up.
The RAID0 creates without problems but doesnt show up in Windows 8.1.
As long as no partition within the RAID array has been created, formatted and gotten a drive letter, you will not see this "raw" drive within the Windows Explorer.
Open the Disk Management. There you should see the RAID array.

#3 RE: 2nd RAID0 doesnt show up by icedon 16.02.2015 10:23

Hi Fernando,

thanks for your quick answer. I didnt specifiy that the drive didn't show up in diskmgmt.msc.
Funny thing though - after deinstalling the RST GUI and several reboots, the new RAID0 array shows up in diskmgmt. I just assigned a letter and started copying.

Thanks Fernando,
Don

Xobor Forum Software von Xobor
Datenschutz