NvmExpressDxe_4 installed, no changes ...
I'll try without a video card, I'll write it.
I do not want to use other methods, because this is more correct.

Hello dear friend)
Everything begins to clear up, modification of the BIOS is not the reason.
On the standard BIOS firmware, when loading the Windows from a flash drive, the video card inserted in PCIe 3.0 x4 still works in 2.0 x1 mode ...
The problem is still in the motherboard, I'll knock on technical support, thank you, sorry for bothering me)

With the built-in video card the same situation. Waiting answer from technical support.
Thanks a lot)

Hi,

Could someone please modd mine, I would be very grateful :)


v2103
http://www.station-drivers.com/index.php...mid=169&lang=en

Ok, it wasn't so hard. Thanks,

I checked after and it was like so, so Im all set? :)


Edit: thanks again.

I'm curious, was anyone able to run some benchmarks on a P67 or Z68 with some of the fancy stuff? I'm debating if I should buy the Samsung Evo 960 / 970, or the Optane 800p / 900p, but the fact the Sandy Bridge only allows PCIE 2.0 might degrade the performance too much. Thoughts?

For comparison, I'm currently running an EVO 850, which is adequate, but if I can squeeze a bit more of performance out of my i5-2500k before upgrading, that would be awesome :)

Dear Fernando, hello.
I have been visiting your page a lot lately, reading your post. I have got an HP EliteDesk 800 G1. Recently, I bought an NVME SSD Kingston : https://www.amazon.it/Kingston-KC1000-So...+PCIe+NVMe+HHHL

I could install Windows 10 into it without any issues. Sadly, I can't boot from it, and for now i'm using the clover usb bootloader method.
Following your instructions, I already updated to my latest bios available (L01 02.70 based on HP website for my exact model), then I modded the very same .bin bios image file and added the latest NVME modules. Could you please check if the file is correct? You can find it here: https://mega.nz/#!iBEgWIbD!DW91wv0B_O6Tw...g84RKX8uEtqP9uM

I tried already to flash this file from BIOS \ Flash System Rom, but it told me almost immediately 'Error Flashing System Rom' without any consequential harm. Could you please help me out?
My system BIOS:
https://www.youtube.com/watch?v=Sf4DfLTw-yI

Weird thing is that HP told me that I was good to go with it given I had NIC options in the BIOS: Link here. Don't know why it redirects.
Simply my BIOS cannot see the KC1000 as booting device.
Thanks for all you have done.

Dear Fernando,
many thanks for your prompt reply.
Please find the original BIOS here: https://mega.nz/#!bV1xnSBb!DbC4roV_d6Mtm...ElOgCXz7LbqdPEg It's downloaded directly from HP support.
Weird, I thought I selected the very last DXE I have found. Please, in case could you patch it for myself? And tell me if you find the mistake?
I thank you.. and sorry for the troubles.