can you tell me which driver should i install for windows 10 64 bit? i cant install the v5.0.4.43 because windows wont allow the certificate to "pass" only when i do advanced restart while pressing f7 which tell windows to allow drivers without certificate to load, but even then when i test the driver and try copy a big file using usb3, it doesnt copy it in any speed close to what it should.
and suggestions?

first of all i imported it an older version of the driver which was imported ok and worked ok after that so there should be a certificate already imported.
this is time i ran as an admin that batch file "ImportCertificate.cmd". a screen copy of the message is attached.

is the new certificate is the same as the older one? in other words should the old certificate allow the installation of the new driver?

when i try to install the new driver i get this message in a small box in the device driver: "Windows cannot verify the digital signature for the drivers required for this device. A recent hardware or software change might have installed a file that is signed incorrectly or damaged, or that might be malicious software from an unknown source. (Code 52".

ok.
so why do i get this code 52?

But also after installing the driver using Windows advanced startup using the f7 key to load drivers which are not signed, even then the driver didn't work as it should. It was very slow.
Any idea?

the attached picture is after i loaded the new driver using the f7 key in the startup settings (picture attached).
as you can see in the picture there is almost no change between usb2 (20 m/sec) to usb3(27 m/sec).
what are the speeds that it should get to?

in the picture attached above you can see the speed.

i checked and there it is like your picture.

maybe is there away to remove your certificate and install it again?

@Fernando,
On my X99 PC with the "certmgr.msc" command I can see twice identical "Win-RAID CA" with expiration date 01/01/2040.
Do I have delete one of them ?