Oh, sorry for taking your time.. I hope this is it?
I found under System devices and PCI Bus these Hardware IDs

ACPI\VEN_PNP&DEV_0A08
ACPI\PNP0A08
*PNP0A08

I am not sure if I installed that "switch" driver, not even sure where to find it. I just followed every driver from their website for this laptop model..

It says "Intel 5/11/2017 driver version 5.0.4.43 Win-RAID CA" :)

@Fernando,
Doing a test on a fresh W10 64 Home FR installed 1703 version onto a fresh cleared 960 PRO SSD system onto my Asus Sabertooth X99 I get via the DPinst64 (administrator) method for Intel USB 3.x v5.0.4.43 a Red Error message such as not installed .. consult your supplier.
Installing previously the ASMEDIA USB 3.x driver using the DPinst64 method was OK.
Why that problem with Intel USB 3.x driver only ?

@Fernando,
Thanks for your follow up of this problem.
As I have to configure the machine to do a test to reproduce the problem (twice attempts was done) and I have no longer the possibilty for several days doing that, I can not answer to your questions.
However I had used MEGA for the package downloading.
The error is immediate and after the reboot the MS USB3 driver does remain and working.

Fernando,
None of the 3 drivers have been successfully installed.
The DPinst64 procedure is completed with the red error message for each one of the 3 Intel USB drivers.
The in place MS natif USB3 driver does remain intact

Zitat von Fernando im Beitrag #1089

---

Attached is the "64bit DPInst Set with Intel USB 3.0 Drivers v1.0.10.255 mod+signed by Fernando". These are the latest Intel USB 3.0 drivers, which natively do support the Intel USB 3.0 USB devices of Intel 7-Series Chipsets.
All I have done is making them additionally compatible with Win10 and giving them a new digital signature.
You can install these drivers the same way as the v5.0.4.43 ones.
What we do not yet know is the impact of the current USB 3.0 Controller "Code 10 error" on the installation procedure.

---

@Fernando

I'm having a similar problem on my dell system. Every time I updated without problems, but on the 5.0.4.43 it says the driver wasn't signed. No matter the method I used, even manually importing the certificate, after the installation (by DPInst or forced) it says that "Windows blocked the installation because the driver is not digitally signed" despite it ia signed. When I reboot it keeps on diagnostic PC mode and I have to restaure to system.

I also tried both ways on the Dxdiag digitally signed WHQL box, checked and unchecked, but the problem persist. In any case could post the link to the 5.0.4.42? I can't find it in the forum anymore.

It is a Dell Inspiron 5567. I on a freshly installed Win10Pro x64 CU.

Many thanks.

I want to add a tip if anyone has the same problem for the asmedia 3.1 controller.
I have a pcie usb 3.1 asmedia asm-1142.
Every driver above 1.16.41.3 WHQL (the old one) it cant detect properly several different mouse .

The last 1.16.47.2 works ok for hard drives but the mouse connect and disconnect every 2 sec.
only the 1.16.41.3 works ok.