Hi again plutomatic, excuse and allow me abuse your wisdom and knowledge. I have found a new Intel management installer versión 10 for H87 series, but this is for desktop versión, please could you tell me if it is valid for my latop, please?

I read in the below description it is valid for 9.0 firmware and fot taht i have thought perhas can be valid for my laptop.

the links are these:

http://es.msi.com/support/mb/H97MG43.html#down-driver&Win8.1 64

http://es.msi.com/support/mb/H97M-E35.ht...n-driver&Win8.1 64

ok, thanks plutomaniac, the i left my system so for the moment, a sincerely greeting

Plutomaniac you are on truth, the usb 3.0 problems continues. Do you know how i could to opdate the firmware for usb 3.0 ? i have been searching about this and i have read tons of problems about this.
My problema is with Intel® USB 3.0 eXtensible Host Controller Driver for Intel® 8/9 Series and C220/C610 Chipset Family.Connectings and disconnectings continuously, where i can ask in this fórum about this? waht is the correct section? greetings

Thanks Fernando. I´m running on windos 8.1 x64 and driver is 6.3.9600.17393. date 06/10/2014.
I have tried to do this but i can´t do it, i have problems to do it.
http://plugable.com/2012/12/01/windows-8...st-controllers/

Thanks to both. Fernando ,mines are the same as yours. Plutomatic, i found these but when i tried to install a message showed they are not compatible with my system. Please, could you tell me how i have to edit them to jump the restriction installation, please?

Note: i searched and i found how to do it, i will post results

Plutomaniac, i have just to install the drivers you posted modifiying the inf file and works fine for know. I have to check during more time, because the other past day, at first after updating mei firmware worked fine too, but some days later back the problems. Plutomaniac, how could i know if my usb is renessas or not? how could i know waht is my chip for usb ports? thanks again for all

Edit : Now i copying a very big file , after i will post the results

First file with 12gb, ok

Second file 80 Gb, when copying 15Gb fail.

This is a nightmare,MSI service is the worst service i never known, 5 messages to support service i one year and any answer.

Plutomaniac do you know if i can update firmware for usb ports? i don´t know waht chip i have, if it is renessas or wich, how could i know it?