I have a JMB36x SATA controller card with DEV_2363 and ROM v1.07.24. According to its supplier there is no newer ROM available, but ROM v1.07.28 and v1.08.01 in post #2 of this topic seem newer. Can these be used and what is the flash procedure?

@Fernando

So, if I have any problems like for example performance issues under Windows, should I blame the driver and not the ROM?

@Fernando

Zitat von Fernando im Beitrag #1414

---

If you have problems with your JMicron RAID add-on card, you can blame everything and everyone (inclusive me), but you will have to find out the responsable yourself.

---

@Fernando

a) If two drives are connected simultaneously on the card then transfer rate (reading/writing) drops. If only one drive is connected then transfer rate is fine.
b) I don't use RAID.
c) Latest JMicron driver version 1.17.65.

I have a motherboard Asus z170 pro gaming. My Intel Raid Rom is 15.2.1.2771. what is the latest Intel Raid Rom? Or best for my motherboard? Well thank you

So i understood that my current version 15.2.1.2771 is fine and you better not do anything? Or go to version v15.5.2.1054 or max. v16.8.3.1003 ? what would you personally recommend to me. Thanks

Hi Fernando,

very first time to ask here. Thanks for your efforts!

I have a Supermicro X10SAT and would like to mod the bios and upgrade the RAID ROM, it is an C226.

For this, I am not sure about which version or RSTe ROM should I use. It come with an "Intel RSTe RAID ROM/EFI BIOS modules: v3.8.0.1029". A bit confused with that is my MB support V.4 or V.5?

X99 = C226? Seems not.

Hi Fernando,

I have no idea too, it come from Supermicro and from the lastest BIOS, it is already there. For me, another Gigabyte Z97, it use v.13 RST normally.

For your questions, that is a long story.

I use Windows 10 (19041.450) normally and try to update with the latest build (19041.508) and It returns BSOD (Page fault in non-paged area). After applying the update and reboot, it will have bootloop without a clue.

I have LSI 9271-8i on my X10SAT, both with latest drivers and firmware/BIOS.

· I try to apply the latest update (19041.508) via windows update, but resulting BSOD (page fault in non paged area), I have to rollback to (19041.450), not rollback, but to use clonezilla to restore, as I can't access the safe mode, bootloop at attempt to repair screen, never see any clue.

· I tried to clean install (508), with LSI 9271-8i attached and elements are there, no luck. But that is OK to have install in (450).

· I tried to clean install (508), with Intel onboard, running in RAID 0 with only one drive, no luck. But that is OK to have install in (450).

· storport.sys BSOD for (508), I couldn't access the very first screen. But I had no problem in (450) and installed normally.

I also try to use UBU to update anything except the Intel RSTe, no luck. So I would like to have a try. I had contacted Supermicro they said I have to talk to microsoft, and no answer from MS for such a case.