Zitat von Fernando im Beitrag #392

---

Zitat von pipes80 im Beitrag #391

---

In this bios: http://download615.mediafire.com/w2s2845...5o6z/x58aoc.f5e there is a same rom 91a2b.bin

---

Ok, that is an older BIOS version for the same mainboard, but did the Marvell OROM work?
Is it possible to create a Marvell 91xx RAID array with this OROM, which supports another DeviceID than the on-board Marvell RAID Controller has?

---

I am enter in raid configuration and this is the version I use now: http://i59.tinypic.com/2enu8u0.jpg
You can create with this: Marvell_AHCI-ROM_DEV-9182_v1.0.0.0032?
And all component for create image for bios?
I have try with this: marvell_88se91xx_firmware_2.2.0.1125b but no work :-(

EDIT by Fernando: Unneeded quoted text deleted (to save space within this thread)

Device id is: PCI\VEN_1B4B&DEV_9182&SUBSYS_B0001458&REV_11

You can create an image with this: marvell_88se91xx_firmware_2.2.0.1125b
Marvell_AHCI-ROM_DEV-9182_v1.0.0.0032
and other component to create an image?

@pipes80

If this is not too late and you're not too scared about flashing a modded BIOS...

I have updated the following:
- Intel RST RAID from 10.6.0.1091 to 11.2.0.1527 with TRIM in RAID0, provided by CPL0 and Fernando
- Marvell 91A2 from 1.0.0.0017 to 1.0.0.0034
- Realtek PXE+RPL from 2.39 to 2.59

Because of the error with the bad table, I had to use a manual replace with a hex editor. I also added a dummy.bin, to have all other modules in their original place. The problem was with correcting the checksum, with cbrom 1.98 doing something funny with EXTBIOS.bin, no matter what I tried. So I used cbrom 1.55, which left all the modules intact, just replaced some padding with some information regarding sections. I think the original BIOS was badly compiled, so let's hope everything is now corrected.

There was another problem with the CPU microcodes, where cpu000206C2 has been added twice with a different version (ver0000000F_plat03_date#18-06-2010 and ver00000014_plat03_date#11-03-2011) and cpu000106A5 can be updated from ver00000011_plat03_date#14-04-2009 to ver00000019_plat03_date#21-06-2013. But since there is too much work to be done with cutting, adding, reformat dummy.bin - I left this untouched. You should check your CPU and see if you have a CPUID in the list above.

If you want to test another BIOS with some older components, there is one in this section.

Edited: Reuploaded the file, because I have provided the one from the above link, by mistake.

Zitat von lordkag im Beitrag #398

---

If this is not too late and you're not too scared about flashing a modded BIOS...
I have updated the following:
- Intel RST RAID from 10.6.0.1091 to 11.2.0.1527 with TRIM in RAID0, provided by CPL0 and Fernando
- Marvell 91A2 from 1.0.0.0017 to 1.0.0.0034
- Realtek PXE+RPL from 2.39 to 2.59
If you want to test another BIOS with some older components, there is one in this section.

---

@pipes80

Your CPU appears to have the affected 0206C2 CPUID. This will remove the older duplicated microcode and update the other one:
- CPUID 0206C2 : ver0000000F_plat03_date#18-06-2010 is removed. Kept only ver00000014_plat03_date#11-03-2011.
- CPUID 0106A5 : updated from ver00000011_plat03_date#14-04-2009 to ver00000019_plat03_date#21-06-2013
- CPUID 0106CA : added to preserve the original size of NCPUCODE.bin

The rest is the same as previous modded BIOS. Reuploaded the previous BIOS, I mixed up the archives.

Zitat von lordkag im Beitrag #398

---

If this is not too late and you're not too scared about flashing a modded BIOS...
I have updated the following:
- Intel RST RAID from 10.6.0.1091 to 11.2.0.1527 with TRIM in RAID0, provided by CPL0 and Fernando

---

Hello Fernando.

I hope you can tell me if I am in the right forum right now.

I'm looking for the Z97 OROM-Asus Maximus VII and Im unable to find it.
Been advised in other forums that the 13.x.x OROMS for the Z97 chipset are located in your website.

Would you be kind to point out the right place to find them?

Also, as per my current knowledge, are the 13.10.1058 drivers from intel the most up to date for either Z87/Z97?
Intel(R) RST/RSTe Drivers (newest: v13.1.0.1058/v4.1.0.1046 WHQL)

Thank you.

Zitat von Fernando im Beitrag #404

---

@ SoniX:
@ lordkag:
New ASMedia 106x AHCI ROM?
Today Station-Drivers has presented a new ASMedia 106x Firmware v3.70 (look >here<).
After having downloaded and opened the package I found a file named ahci_370.rom dated 01/20/2014. This firmware can be flashed by the attached installer, but seems to be usable as well as AHCI ROM module after having removed the header.
If anyone wants to look at it, here is the download link: >ASMedia 106x AHCI ROM v3.70<

---

Zitat von Fernando im Beitrag #404

---

@ SoniX:
@ lordkag:
New ASMedia 106x AHCI ROM?
Today Station-Drivers has presented a new ASMedia 106x Firmware v3.70 (look >here<).
After having downloaded and opened the package I found a file named ahci_370.rom dated 01/20/2014. This firmware can be flashed by the attached installer, but seems to be usable as well as AHCI ROM module after having removed the header.
If anyone wants to look at it, here is the download link: >ASMedia 106x AHCI ROM v3.70<

---