When i have patched with microcode, and other updates i get project id check fail when try to flash.. try only microcode and see.. used the winflash setup that come with bios.

after patch id mismatch, project id mismatch.. why?

the microcode is the most wanted one becouse i will swap the cpu to a ivy from sandy..

If the BIOS wasn't already IV compatible, then we can not make a SB BIOS work with IV by just by adding its microcodes, it requires many more parts...

ok i see, i have a cpu that i have bought and wanted to uppgrade the laptop. can it be done? will some one look at it?

Zitat von Tommyl im Beitrag #192

---

... will some one look at it?

---

This one might concern Sonix.
It seems that the BIOS posted by Tommyl has some problems with UBU. First, it has two VBIOS for the same controller 8086-0106 (2098 and 2080), which makes UBU failing at replacing them. I think one is left over and should be deleted. Second, there is another Realtek FE Family controller with ID 10EC-8136 v1.24 which can be updated to 1.34.

Question: can the GopDriver be inserted without other modifications, or it has to be compiled in the original BIOS? Has someone found anything about IntelSaGop and GopPolicy (for Insyde), how they must be tweaked, how are they related to the Gop?

if all the update for ivy bridge with gt2 hd4000 will work on my laptop i wil flash it, if no ivy with hd 4000 but just update the other things i will send back the i3 3110m cpu and just leave the laptop as is. I ordered a 128gb ssd and the 13 3110m to replace the i3 2310m for more mhz and newer gpu hd3000 - hd 4000.

i have asked for return of the cpu if this project is too deep to make ivy work on this one. So if someone ho is looking at the bios would say its possible and "safe" i will keep it.

Thx

Hi,

with GA-Z77X-UP5TH and 12j bios, at "EFI INTEL UNDI" I get the message "Unknown version. Please contact me."

At Marvell sata option rom i get double entry "Marvell 88SE91xx/92xx -1.0.0.0027" instead of one entry.

Also when I extract a efi module to manually replace in other bios, i choose "extract as is" or "extact UnCombressed"?

And final, when i extract the intel lan rom from CSMCORE, mmtool says 8086,1503

but when I look the extracted rom with Hex Editor , I see that it is 8086,1502


ps: where i find in mmtool the EFI intel UNDI module, so I can extract it and see it?

sorry for the long post and I want to thank you again for this very nice forum

Thank you for your fast response,

so when I will replace the efi module, it doesn't matter if it is compressed or uncombressed?