bro i just tested them out now! lol!
so here is the result after i flash the 2926new file
i think it went to 2800mhz... now what next? i am excited lol

EDIT- I also tested the 2666c18 one but after flashing successfully nothing changed on reoot , it is stuck on the pic i have sttached earlier in the post... i dont know why?

Nice! So, maybe 2800 is limit of your chipset or CPU. SO, we can make you proper one for 2800 (using hard set 100x14, so it's 2800 exactly) later if you want.

Show me CPU-z memory tab image after testing the 2666C18 file

there you go, i tried flashing twice when i dindt see any change after reboot
maybe it was due to low voltage..?

Did it double or triple reboot, after you applied and reboot? If not, then it's not failing to load/try the timings.
It may be due to all three need to be changed at once or BIOS doesn't like it, I am surprised to see the command rate still 2T though, let me check things out and send you a few new test files in regards to this
* Edit - OR MAYBE... They don't go in as hex, but straight text/decimal. I set 12 which = 18 in hex, but I'd expect a failed reboot attempt if it was using dec/text because C12 would fail hard.

No it rebooted only once.

Thanks, good to know, it can't be a hard fail or using text/decimal then, or it would hard fail. Try now - http://s000.tinyupload.com/index.php?fil...974496262147190

ok so i flashed new one and the result is

Hmm, OK, please test both of these, show me CPU-z for both
http://s000.tinyupload.com/index.php?fil...338508683798278

i tried and result after dec file-
result after hex file
why isnt it changing from 2800mhz?

Right, something is up! Both of those have set 0A for memory multi = 10x, so should be 133x10 = 1333/2666
And, no double/triple reboots or anything odd like that?

OK, try these - Should be 2400Mhz, and C20 or C14, going back down to 2400 so we can sort this timing thing first, safer there in case C14 is applied (if so, that may be too low for these memory and 2400 too, we may need to test 1600-1866 to be sure)
http://s000.tinyupload.com/index.php?fil...994765981251920

yeah nothing odd

Here, maybe I need to enable overclocking to allow memory timing changes? Would be odd to allow memory speed change without it, but block timing changes, but best we check. Did above at #100 to back down to 2400?
http://s000.tinyupload.com/index.php?fil...957796532927886

If still same, and 2800 after this, enter BIOS, load optimal/defaults on the exit page, save and reboot back to BIOS and make any disk/boot priority changes you need, then check and see if memory speed reset back or not
Then re-test these above again.

i tested what you said earlier in 100th post , the results are after dec file
after hex file

i flashed these oc enabled ones the result are
1. after dec
2. after hex

i dont know why after flashing hex one laptop felt slow also cpuz crashed once

Hmm, 2200 instead of 2400, odd to see there! Test these now, same but with QCLK odd enabled, since the above should have been 2400, still looks like timings are ignored.
http://s000.tinyupload.com/index.php?fil...385183088691909