@ Ricks:

Read Section A carefully.

Intel CSME 11.8 Corporate PCH-H Firmware v11.8.50.3460



Intel ME 9.1 5MB Firmware v9.1.43.3004



Intel ME System Tools v9.1 r5

Intel ME 10.0 5MB Firmware v10.0.57.3000



@ TigTex:

Intel MEI Driver v6.2.50.1050 (AMT 6) INF for manual installation
Intel SOL "Driver" v6.2.50.1060 (AMT 6) INF for manual installation
Intel MEI v6.2.50.1062 (AMT 6) Drivers & Software

Intel MEI Driver v12.0.1069 MEI-Only Installer
Intel MEI Driver v12.0.1093 (Windows 8 & Windows 10) INF for manual installation
Intel MEI Driver v12.0.1093 (Windows 7) INF for manual installation
Intel MEI v12.0.1102 for Consumer systems Drivers & Software

The latest v12.0 drivers are usable with 8-series Broadwell mobile & 100-series or newer desktop/mobile systems (CS(ME) >= 10). Users of 9 & 8-series Haswell desktop/mobile systems (ME 9), must use the latest v11.7 drivers instead. Users of 7 & 6-series Ivy/Sandy Bridge desktop/mobile systems (ME 7 - 8), must use the latest v11.0 drivers instead. Users of 5-series or older desktop/mobile systems (ME <= 6), must check Section D to find the driver they need. In order to check your current installed version, use Intel MEInfo tool as instructed below.

Intel CSME 12.0 Consumer PCH-H Firmware v12.0.0.1069



FWUpdate Region (FWU): Starting from CSME 12+, Intel FWUpdate tool does not work with all RGN or EXTR CSE firmware images as it additionally requires the presence of PMC firmware, in order for the latter to be updated alongside the main CSE firmware. For that purpose, Intel provides FWUpdate Region (FWU) images to OEMs which are very similar to RGN but with the PMC firmware partition (PMCP) appended. These images are targeting FWUpdate tool but since they are based on stock RGN regions, FWU are also clean and unconfigured and can thus be used with Flash Image Tool (FIT) without any issues. To check if a CSE firmware region is FWU, input it at ME Analyzer tool and make sure that "Firmware Type" is reported as "Region, FWUpdate". Since FWU regions (like RGN) cannot be extracted from SPI/BIOS images and are only given to OEMs, you can use modified EXTR images with PMC firmware partition appended, in order to initiate FWUpdate tool, when a FWU region Type of a given CSE firmware has not yet been found. Note though that any such modified EXTR images with PMCP added will still be reported as "Region, Extracted" at ME Analyzer tool, even though they can now work with FWUpdate tool. To check if a CSE EXTR firmware region is FWU-compatible, input it at ME Analyzer tool and make sure that "FWUpdate Support" is reported as "Yes". The CSME v12+ archives below always include FWU or FWU-compatible EXTR CSME firmware images.

Intel CSME System Tools v12 r1

Zitat von Yuno im Beitrag #3872

---

So which brave soul will be first to try shove ME 12 onto a Z170 board?

---