How did you solved the issue ?
I am also getting an error "Error 8714: Firmware update not initiated due to file [6.2.61.3535.bin] open or read failure" in a different motherboard.

Thanks

1803.12.0.1093 MEI driver , " not supported on this platform "...........???
How is possible , now using version 11.7.0.1057 on Win10 x64 .
Seems not possible to update to this latest driver , while some driver-update software saying ; have to update to 1803.12.0.1093................!!??

Any advice..........??

Win10 1709, latest build , ASUS Z97-K, latest bios.

Thank you , so my 11.7.0.1057 is latest for sure !!
I can ignore this " update " and will wait for update which will support Haswell CPU .

On my Z97 I have installed latest 11.7.0.1065......

" On my Z97 I have installed latest 11.7.0.1065 "............not true !
This is the number of the driver-pack , when you look at the drivers, inside , you will see they all have version number ; 11.7.0.1057 !
These are the same drivers as I have on my Z97-K , there are no newer , so far..........

Yes, I meant driver packs.

Hello.I have a asus laptop N550jv with windows 10 .When i try to install MEI driver got this massage:Your computer does not meet the minimum requirement for installing the software.
Motherboard Chipset: Intel HM86 (Lynx Point)

I have been reading this very interesting thread and tried to use the provided Clock Control Tool for the ME and I am getting 'Error 4007: MEI INITIALIZATION FAILED'.
I aquired some documentation on the CCT and how to use it and it has a section on error messages but unfortunately I am not sure why the initialization failed or what it would indicate beyond perhaps an incorrect driver/firmware version.

Do any of you know how I could figure this issue out so I can get CCT to run and is this an indicator that I perhaps need to update my ME firmware?

@plutomaniac

I installed the driver from section A and I was able to run all the tools.
I previously downloaded my other driver from Intel but obviously I did something wrong ;P

Need flash image tool 9.5.12.1676 plz any one upload plzzzzzzzz

Hey, i flashed the latest "Intel ME Firmware v9.0.31.3488 (5MB)" and installed the latest Drivers & Software "Intel MEI v11.7.0.1065 for Consumer systems" for my Gigabyte GIGABYTE H87-HD3.
But after that iam also vulnerable to INTEL-SA-00086.
Is there any way to get this vulnerability closed?

I have a Maximus Ranger VIII motherboard and after updating the MEI, the CPU temperature went up by 10ºc. The CPU voltage was also incorrect: sometimes 0.16v minimum and 4.08v maximum, which is impossible. What could have gone wrong?