I will apply this guide ( [Guide] Using CH341A-based programmer to flash SPI EEPROM )
Which I file send to you?

-------------------

I tried everything and laptop not opening. Pc is trash

@knygn - If you used the guide you linked above you should have stopped at step #4 and send me that file. Same as I said on page one post #15

PC is not trash, you can fix it easy! Send me the original dump from your chip, that you made from that guide following steps 1-4

I followed all steps. Read -> Erase -> Program
Pc is not opening now.

Do you have any idea that how can I fix?

@knygn - per post #15 "All steps" would be >> Goal of first action is to dump both chips contents and send to me so I can check it's Ok, and then edit/send back and tell you how to write.
Once connected you will read, and then verify. Then if buffer/chip match, save the file and zip and send to me.

No one mentioned for you to to erase or write/program anything yet. I have to make you BIOS, and or rebuild ME FW etc, then compile new BIOS for you, then split into two parts etc and you program both chips with the two parts of BIOS I send you.

What did you even program, what BIOS??? And to what chip did you write??

Did you dump both chips (ie read, verify, save) before you erased or wrote? If not, we can still fix, but you may have lost your LAN MAC ID (No ethenet, unless you can find MAC ID on sticker or in router logs), and you loose your Asset tag, service tag, and serial probably.

Please dump both chips contents for me now and put into single zip, then upload to one of the sites below
https://uploadfiles.io/
http://tinyupload.com/
https://www.filedropper.com/

I repeated many times of Read process (sometimes there was contactlessness). Now I have 5 bios file for just one chip (other chip does not unknown).

https://ufile.io/x6qcbg26

Can you check all bios files? Maybe one is correct. Thank you

Thanks. Did you do this before you erased and wrote first time (Before)? If yes, also send me those files. What do you mean "other chip does not unknown"? I need dump from both chips, not just one

If there is no contact, reseat clip, no point to read/save if no contact

I read just one chip. The clip did not see the other chip. I have two bios files more (hopefully before erased)

https://uploadfiles.io/ftqpv8k2

@knygn - Need dump from both chips, preferably before you wrote or erased either one. What is the ID of the other chip, then I can tell you software that works with it.
It's not "The clip" making you not be able to see it, unless you aren't getting a good connection, it may be the software version.