plutomaniac - Thanks, happy to help when I can. I do not see "Sections" I only use view latest post link at top, always then help when possible. I do try to sit back on threads when I know you are helping or better one to help, because you are much better at this than I, and usually solve in a much quicker way than I do too

@pg - what is "Screen 1" - never mind, you meant image one, sorry! That is not good, should be OK to start, hopefully plutomaniac will know what to do! You may need PSWD one there always, and another on FDO too.
Find another jumper, or short FDO pins with something metal like a tiny clip. Probably grab a jumper off another board laying around if you have any, especially older ones.

https://www.itouchbiometrics.com/Manuals...%20600%20G2.pdf

ok one moment please

not start ((((

- Please edit your posts while you wait for someone to reply, don't post consecutively
Sorry, not possible remove posts. No button delete...

- Now, FDO is definitely what you want and it should work by itself
If the jumper in the FDO or FDO+PSWD position of the PC does not start...

- meaning E1 at [Guide] Unlock Intel Flash Descriptor Read/Write Access Permissions for SPI Servicing.
thanks, I'll try

using method: Unlock Methods for SPI Servicing

Shutdown the system completely (S5 power state)
Locate the two HDA pins and start shorting them
Keep shorting the pins and power on the system
Once the BIOS/OS starts to load, stop shorting
The Flash Descriptor should now be unlocked



when closing the pin computer just does not want to turn on ....
Symptoms are the same as with a jumper

does it turn on for a second and then turn off immediately...

in jumper or pinmod


sorry for the wrong explanation
I mean:
not start - not POST initialized
not boot - not start OS

I understand you, I'll try E5 and E6

CH341A flash programmer can be used on this system without desolder/solder the BIOS chip. You need to order SOIC8 test clip with cable as well, to use with the CH341A flash programmer.

Hopefully you can get it via E6 method, I'm not sure why FDO jumper causes no POST, it should work! How long does the system stay running when you try that, listen or look at the fans? If it stays running, then maybe it's a graphics setting issue? Try it with the FDO jumper on there again, but try all other graphics options to connect to your monitor.
I mean if you are using HDMI now, try also with monitor connected to VGA, then it nothing on screen try with DVI, etc. Also, be sure to try the onboard motherboard graphic options out the rear too, if you are now using some PCIE card rear ports for graphics

- How long does the system stay running when you try that, listen or look at the fans?
Yes i'm look at fans.
he is It starts spinning and stops in 2-3 seconds.
This behavior is also observed when we used metod "E1" "Pinmod"

NO beep, no POST....

That's not normal behavior for this feature You will have to order Ch341A flash programmer and SOIC8 test clip with cable, or a kit like EZP2010 or EZP2013 that comes with test clip cable already (First two things I mentioned will be cheapest option $2.50+3.00)

Or wait for another reply from plutomaniac about E1 option, maybe you did that wrong? I think it should always work when done properly?