Remove Power Supply Unit cable for 5 minutes.

Didn’t work, trying the beta bios now

Try also uninstalling DIP5 first.

ok bios says N/A but into windows and i went to load me drivers 11.0.0.1155 and it says version 11.7.0.1045 is installed ?
Does it need to load into windows to show the me in bios , should i downgrade the me version ?
@Sylar76

In windows in device manager under imei it has this
This device cannot start. (Code 10)

STATUS_DEVICE_POWER_FAILURE
also this under usb
Windows has stopped this device because it has reported problems. (Code 43)

A request for the USB device descriptor failed.

I think you have a faulty motherboard or something wrong. I'm very tired about this situation. All I can say is to have tried everything, thus
I'm very sorry I couldn't help you.

Yes i think the same after i last posted the pc shut down after restart no imei in device manager i think it is stuffed .
Thank you for all your help @Sylar76 and @Lost_N_BIOS you guys have been awesome in trying to get this problem sorted out.
Enough time has been spent on it so its time to return it and get a new board. Thanks again for your time and efforts
Sav

Wow, I agree with @Sylar76 that should not be happening with ME, especially due to FPT operation pass 100% OK, and same with flash programmer. Both/either method should have fixed this problem immediately.

Have you done a ME state reset via fptw -greset or full power drain for over one minute+
Full power drain = Remove PSU connections, remove CMOS battery, press and hold power on button or short switch for 10-20 seconds, then let sit for 1+ minute before putting power back

If the above does not fix it, send me new current dump of BIOS contents via programmer dump, and I will see if anything looks wrong.
The above may fix it, since you haven't mentioned doing either method after any of the ME flashes

I did the command reset with the methods before post119 but not after . With post 119 I did power cable disconnect for 15min but didn’t remove cmos battery
@Lost_N_BIOS

Full power drain from board for 1+ minute is all that's needed (Including no battery), or issue fptw -greset command. That might not fix it, but it should be done any/every time you are updating/changing ME

So if I do it now may work with the command fptw -greset ?
I will also send you a dump of the file @Lost_N_BIOS

Tried the commands again and power drain with cmos battery out still no good .
Could this be because I used the latest beta bios in the ftk9 program which isn’t unlocked?

I don't know about BIOS you mentioned, or what unlocked means in regards to it. Please use latest BIOS posted in this thread, since Sylar76 made for you, I think at post #84

With post 119 I used bios from asus as the modified one would no work and came up with errors.

You are using a programmer, there should be no errors. What error do you mean?
Modified BIOS would work same as stock BIOS for method in post #119, please try again any error is due to commands given most likely.

None of that is necessary anyway, you have flash programmer to avoid this kind of hassle. Use programmer and BIOS in post #84, all problems solved as long as you erase chip, blank check, write, then verify in that order and verify completes correctly (Chip and buffer/main memory match)
After that, remove all power to the board, including CMOS battery for 1+ minutes and press and hold power on/off button or short pins for 10-20 seconds while no power connected to board too.
Then start system after 1+ minute with no power