I have an Asus P5E3 Deluxe/WiFi-AP (X38 Chipset) With RAID1 SSD's 2 x OCZ VECTOR 150 of 120GB (VTR150-25SAT3-120G).
This volume is bootable with Win7 64bit.
As the motherboard has the Intel ROM 7.5 i update it to intel RAID ROM 11.2.0.1527 with the instructions found on this forum.
I use the latest 1502 BIOS with only modification the intel RAID ROM 11.2.0.1527.
I use the Intel RST Driver 11.2.0.1006 for win7 x64.

Everything works fine and the computer is super fast but i have 3 problems:
1) Everytime i do verify the volume from Rapid Storage console i get 65535 Verification errors
2) OCZ toolbox says "No Supported Drives Found"
3) TrimCheck (github.com/CyberShadow/trimcheck) Says that TRIM is not working.
Note: The "fsutil behavior query DisableDeleteNotify" Reports '0' which means TRIM is enabled.

Is there something i can do to enable TRIM on my disks? I have read that RAID1 TRIM is supported since Intel 9.5... RAID0 is delayed but RAID1 should work...
Why Ocz toolbox doesn't recognise my disks?
Why i get so many verification errors? Other 2 Raid1 volumes i have (Non SSD Disks) doesn't have this verification errors problems.

Should i change the ROM and driver version to another?

What actually mean that i can't enable TRIM is that my system will perform slower over time and the life of my ssd's will be shorten?
RAID array i think was created with 7.5 OROM but RAID volume was deleted and created with OROM 11.2

I have deleted the RAID volume and format the disk and installed win7 again in 1 of the disk in non raid. Controller is on RAID mode but disk works as non member of RAID (AHCI).
TRIM Check again says that TRIM is not working....

I was not able to make any combination to work the TRIM on RAID or AHCI.
Finally i done the install in RAID1. VOLUME created from 11.2 ROM with CTRL + I I install 11.2 Driver with F6 and then when windows started i install the full 11.2 driver.
All my original problems remain:
1) Everytime i do verify the volume from Rapid Storage console i get 65535 Verification errors
2) OCZ toolbox says "No Supported Drives Found"
3) TrimCheck (github.com/CyberShadow/trimcheck) Says that TRIM is not working.

..) Everytime i do verify the volume from Rapid Storage console i get 65535 Verification errors

I connect the SSD i had on port 0 to port 1 and the SSD from port 1 to port 0, delete and create RAID again and problem solved!!!
Stupid solution but it works!

Dear Fernando,

Once i connect the SSD's on my system i didn't have change disconnect them.
Only disconnect them and re-plugged on the same port.
Today for 1st time i unplug them and plug them on different port and that solved the problem with the verification errors.

Can you please explain what you mean by: "the allocation of the RAID1 members to the specific SATA port should not be changed"?
I have other RAID1 disks that i sometimes disconnect them and connect them to a different computer (same specs, and sata driver version) and they work. When i take them back to my computer i connect them with whatever order.... I am doing this for Years and never had problems...