Hallo,

Wird hier deutsche Unterstützung auch angeboten? Ich habe eine Rampage IV mit dem aktuell BIOS 4901 installiert. Dann habe ich die Zip Datei runtergeladen und mit dem ASUS AI Suite 1.02.15 das Bios geflasht.. Jedoch wird meine NVME SSD immer noch nicht im BIOS angezeigt(Im Windows ist sie ersichtlich)... Ich habe festgestellt, dass das Bios nicht aktualisiert wird... Ich verstehe jedoch nicht weshalb nicht...

Gruss

Sniper8952

@sniper8952 English only please.

You can only update to moded BIOS using ASUS BIOS Flashback function (with properly formatted pendrive connected to right USB port on the IO [correct port should be marked]).

Hi, All,

Newbie for this forum.

I'm running Rampage IV Extreme with 3960x CPU. Trying to use ASUS Hyper with 2 x NVME M.2 SSD. Can I use 2 x NVME on 1 x Asus hyper PCIE card?
I think Raid should not be workable, but would like to know that I can use 2 x NVME.

Thanks.

Hello sniper.
Ich kann dir gern auf deutsch antworten...
Schau bitte, dass du auch das richtige BIOS bootest. Auf diesem Board sind 2! Ich hab auch eins mit diesem Update für NVME Support und das zweite hab ich noch nicht geflasht. Somit läuft das ganze nur auf einem.
PS: das flashen funktioniert nur richtig über USB am dafür vorhandenen Port.

Liebe Grüße

Sorry for the German talk. I just told him to boot from the right bios, since we have 2 and you can flash both individually. I also just flashed 1 and don't have NVME support on bios 2.
Kind regards.

RIVE booting from a SAmsung Evo 970 Plus 500Gb

The OP's R4E.zip extracts a R4E.CAP file found in the first post wont load in "UEFI Bios utility:. I copied the 4901.CAP also to the same USB stick and it and it loads fine..

Does anyone have any suggestions for loading the OP's

1. format your usb flash drive to FAT32 filestystem
2. put R4E.CAP to the root of the falsh drive, also you can copy the file and place it in the same directory nameв as R4E.ROM (regarding R4E official manual)
3. put your flash drive to OC white usb port
4. turn off the pc, hold the OC connection button until it starts blinking 3-5 sec
5. wait until it starts blinking fast and then stop blinking 3-5 minutes
6. start your pc, configure your bios likes described on the first page

windows 10 installed on Samsung EVO 970 + PCI-E M.2 NGFF for SSD V2 + Heatsink Ret adapter

I had an issue using the provided CAP in OPs post. I tried with many different sticks formatted many different ways, using Diskpart and Windows formatting. None of them worked. I took the time to create my own for RIVE (Rampage IV Extreme) by dropping the NVME driver into a freshly downloaded (ASUS Website) rev4901 bios. I will attach it here for anyone that wants to try this one (in case OPs doesn't work for you too).

***EDIT*** Unable to upload because of file size limit. I have uploaded it to the following:
***EDIT EDIT *** Unable to upload my post because of a lack of posts on this forum (literally registered an account an hour ago to post this to be fair). I have attached a text document that contains many of the same steps plus a MEGAUPLOAD link.

1. Run command prompt as Administrator
2. Type DISKPART
3. Plug in your USB drive. Note the size of the device (which is likely much smaller than your hard drives). WARNING >> THIS WILL DELETE EVERYTHING ON THE USB DRIVE
4. Type LIST DISK
5. Locate your USB thumb drive. Remember the drive number
6. Make sure you have selected the right device.
7. Type SELECT DISK xxxxxxx where xxxxxxx is the drive number from step 5
8. Type CLEAN
9. Type CREATE PARTITION PRIMARY
10. Type ASSIGN LETTER=yyyyyyy where yyyyyyy is a drive letter you aren't currently using
11. Transfer the file attached here to the root of the drive (note I kept it lower case, this worked fine for me)
12. Plug into white USB port on back of motherboard
13. Press and hold the appropriate ROG Connect key until it blinks a few times
14. Wait a while until it is done. The ROG Connect key will slowly blink. If the USB has a light to indicate disk read/write, it will blink too.

First of all thank you to the OP for the information provided.

Equipment Used:
ASUS RIVE from stock bios 4901
aliexpress.com/item/1005003027064941.html
Cheap Aliexpress M2 Adapter PCIe 4.0 X4
Corsair MP400

Connected M.2 adaptor card to bottom red PCIe slot.

The already modded BIOS versions I found in this thread did not work for me. Got an error message "The file format is incorrect. Ensure that the filename extension is .CAP" when trying the file in EZ-Flash and Bios Flashback failed after a couple of seconds.

I went through the win-raid.com/t871f50-HowTo-Get-full-NVMe-support-for-all-Systems-with-an-AMI-UEFI-BIOS.html]process described in this other Win-Raid thread and was able to create my own modded BIOS.

This gave an error message in EZ-Flash that it failed "Security Validation" which I was not surprised by, but using the file in Flashback the update was completed correctly.

here is the file for those interested
mediafire.com/file/k4gihs4b3856r8k/R4E.CAP/file

(I tried to use this site's file upload but got an error forbidding the file type.)