Hi All,
i need your help in the below case for my PC.
I have the following on my PC
Motherboard: gigabyte GA-Z270X-Gaming 9
BIOS RAID: Intel RST 15.5.0.2875
NVMe SSD: 2 Samsung 960 Pro, 1T

BIOS Confirmation that i have is the following
Secure Boot: Disable
Fast Boot: Disable
CSM Support Disable and i try Enable

Windows Boot from USB using GTP

Last Driver that i used : 64bit Intel RSTe AHCI & RAID drivers v15.5.0.1047 Beta

Windows 10 64bit & Windows Server 2016

when i run the installation without any RAID i do not have any problems in the drivers and system run fine.

but when i Configure my PC with RAID 0 or 1, and after the windows run it ask me for the driver when i pick the driver the process of adding the driver take some time then the system Freeze. i can't continue after this part.
can you help me solving is problem.

Thanks for replying Fernando.

How (by using which tool) did you configure your RAID array?
-- I config the RAID Array from the BIOS, by EZ BIOS
Did you delete the previously created RAID array before you created a new one?
-- there was a array before and i have deleted it and create a new one
Which OS is/shall be your system drive (Windows 10 or Server 2016 or both as a dual boot system)?
--my final goal is to install it on Windows server 2016. but i am also testing it under windows 10
Why did you use an Intel RAID driver from scratch, which is not even WHQL certified?
-- I used it becouse it is the last update driver, also i tryed the RAID driver that come with the motherboard f6flpy-x64
Did you unplug all other storage drives except the members of the RAID array, before you started with the OS installation?
--yes i did removed all drivers
Off topic question: Why did you buy such big sized SSDs, if you had the intention to create a RAID0 array and to use them as system drive? The OS doesn't need 2 TB of space, but you will loose up to 2 TB of data in case of a broken RAID0 array.
i need to Use RAID1 as i can't have a signal point of H/W failure