I have been trying to wrap my head around this for days and I just haven't been able to figure this out.
I would like to add the EFI "SataDriver" to the bios on this board to support EFI boot from the Intel controller when it is in RAID mode.
Can anyone tell me which module to insert here? As I understand it, the x79 and the c602 use the same one right?
I do not necessarily need to create or manage the array from the bios, I can do that from the OS, but the boot SSD and the Raid 1 array are both going to be on the Intel controller.

Here is the output from UBU:

Setting the Sata option to Raid, gives me the config utility while in legacy/csm mode.
I have not attemted to install the os in raid mode while in legacy/csm so I have not gotten as far as to install drivers.

The config utility is: Intel Rapid Storage Technology enterprise - SATA Option ROM - 3.7.0.1049

I did attempt to extract the "Satadriver" from a gigabyte x79 based board (same version 3.7.0.1049 )and insert it into this bios, but it was still unable to boot while in EFI.
Nor did it add any raid config to the bios.

edit: also, I presume even this very old version will be able to pass TRIM commands to non-raid SSD's right?

Thank you.

Something is strange here, or I am missing something.

I insterted "Intel RSTe EFI "RaidDriver" v3.8.0.1029 for DEV_2826 GUID 43A0A7B3" as compressed from this thread: Intel EFI "RaidDriver" (="SataDriver") and "GopDriver" BIOS Modules

I then ran ubu:


and then upgraded all to 3.8.01029:


I flashed this to the board, but I still do not get any boot options from the Intel controller, (I will attempt a test install and see it I get the option upon reboot)

Also, when in legacy mode, the config util still shows 3.7. Shouldn't this reflect the 3.8.0.1029?

While in UEFI mode, I installed windows to the drive, but upon rebooting do not get the option to boot from the drive:

Thank you, I will spend some time tomorrow and make sure the modded bios has been flashed.

I have another one of these boards that I was able to successfully add nvme boot support using the same method that I am doing here.

Mod the bios > replace the original bios on the usb boot with the modded one, and run the mfg's flash batch file.

@Fernando

Ok, you were correct sir.

I did an AFUDOS /O to read the bios back to a .rom file, and ran it through UBU and sure enough it didnt have the EFI option, or the updated sata modules.

So I decided to flash directly with AFUDOS and not the batch file that was provided by Gigabyte. Success!

It even added the option within the bios while in UEFI mode to see the disks.

I am curious as to why it shows the 180GB SSD as 167.7GB...also, is there any benefit of updating beyond 3.8?



I am testing it now to see if it is bootable after installing windows to it.

Success again!

Windows Server 2016 Essentials boots from the SSD while in raid mode with only UEFI turned on.

Windows automatically installed the driver for the raid controller (13.2.0.1022) but of course not the management utility (which I will need)

So should I over-write these with 3.8 or get the version of 13 that has the management utility?

Thanks

It is: DEV_2826

Do you know if there is a driver version that would add SRT?