@glnz The BDU from cvad is an installer it will install clover to a usb for you and attempt to configure it for the system you are installing it from, so i hope that is the same machine you wish to boot.

follow my add-on post as well as the op re what to select. I have used this to boot several non uefi bios systems from an nvme. how this works is you installer clover to the usb clover runs first every time you start up the pc and clover then passes off to the nvme for normal windows.

@pxl666

Zitat von pxl666 im Beitrag #808

---

hey can anyone tell me if this method as described in 1st post , allow me to boot win7 system that was cloned from SSD to PCIeNVME (both partitions as disk clone) given the fact that my MOBO is not supporting nvme (windows mounts nvme disk okay and i can use it no problem , just i'm not able to boot directly from bios).
so NO INSTALLATION ... booting to clone .
i cloned the system to another SSD to test it and this works flawlessly as SSD boots from bios .
machine is HP Z210 workstation - updated bios but realized that they did not add nvme support...

---

@CutieJelly

Zitat von CutieJelly im Beitrag #810

---

So i've been looking around the comments trying make sense of this.
I followed the instructions just as said in relpy #493 and the main page. I don't think my BIOS supports UEFI at all, though.
When booting to the USB clover all I get is a black screen with a "_" then a "6". I think someone said theres a problem with windows install, but arn't i supposed to install windows after i get Clover to work as said in reply #489.

---

Thank you for your reply. I'll fool around with it for a while and see if something happens. Thanks again.