You will find fpt.exe or fptw64.exe in the "Flash Programming Tool" folder of the "Intel ME System Tools" package you've downloaded.
Optionally, briefly unplug your PC from power source.

Zitat von toni31 im Beitrag #90

---

First of all i want to thank you plutomaniac for the guide
If i'm not wrong i think that i have clean ME but forgive me i don't understand
section D2. CSE (CSME 11 & CSTXE 3 - 4)
step 15
"Last but not least, once your new cleaned+configured SPI dump or Engine region is flashed on the target system, run Flash Programming Tool with command fpt -greset and wait for the system to reset (no settings are lost). This step is very important because it forces the Engine co-processor to re-initialize and properly accept any changes to its SPI image region counterpart."
How i must to do it?
Thanks a lot

---

Hi everyone,

First of all, thanks a lot for all these great information and files you shared with us.
I have a problem with a Microsoft Surface Pro 4 Bios for long time. I did a lot of things on it and found some clean dump which I cannot use them. That's because of Serial and other special numbers which are saved in Bios. Even if I edit them and replace serial number and MB number, still is not working properly.
My original Bios Dump has problem with its ME Region which is "Con-LP-11.7.4.3330". I'm afraid, I cannot extract any of Con-LP models with Flash ME Tools and always give me error which I attached the screenshot here.

I would appreciate it very much if you can help me to sort it out.

Kind regards,

Hi,

Thanks for reply. I tried with the CSME tools 11 Ver10 and result is the same as the picture I already uploded. I've attached the SPI Dump here and I would appreciate your help very much. Thank you again

Also, I've attached another cleaned SPI dump file which I can turn on the Device, but can't put the SN and MB Hash into it which the machine stuck on Surface logo after editing, which is working fine without changing the numbers. as you know the Device needs to have its original SN and MB numbers to work properly.

Thanks again.

Thank you for reply.
I think something is missing or misunderstanding here. I could and still can split (extract) the SPI dump file, but I cannot extract ME Region file. Any model of Con-LP file I try to load to extract, I receive the error. I put the ME Region File on Desktop and tried again as you asked, but the result is the same. I've attached one the ME Region File and also the screenshot of the error message.

As I said, this error message appear for any CON-LP or COR-LP ME Region Files only and don't have any problem with CON-H or COR-H ME Region Files at all...

Thank you for your time.

Hello there,

I'm afraid you're not answering my question. Thanks anyway for your time

I have error like this my board LA-9771P dell M4800 https://ufile.io/shel5

[[File:Bez tytu?u.png|right|fullsize]]

how to merge it?

Thanks for the advice, I merge my dumbs, I received 2 "outimage" 8mb and 4mb. do I need to replace the contents of both on my motherboard?