Hi guys. After installing 16.7 modded driver , i would like to install the software aswell, but it doesnt work - the progress bar moves forward, but then it backs out and nothing happens. Is there any way to make it work ? I tried 16.5 driver + soft also, the same problem. Forgot to mention: i use Dell Precision M6800 + win10 1809

The hardware id of the controller is PCI\VEN_8086&DEV_8C03&SUBSYS_05CD1028&REV_04 . Im using it in AHCI mode. Its the mobile QM87 i presume. *its a haswell based platform"

Intel dont release official driver for this SATA controller? More info from me:

PCI\VEN_8086&DEV_31E3&SUBSYS_84D6103C&REV_03
PCI\VEN_8086&DEV_31E3&SUBSYS_84D6103C
PCI\VEN_8086&DEV_31E3&CC_010601
PCI\VEN_8086&DEV_31E3&CC_0106

Intel® Celeron® N4000 Processor

Thanks!

Zitat von Fernando im Beitrag #1054

---

Why do/did you try to install the Intel RST Software at all? This only makes sense for systems with an Intel RAID array.

---

hi Fernando!

first of all i want to thank you for your amazing and dedicated support to this entire section, it help a lot of users who rely on notsorecent hardware like me

i have an ancient x58 asus rampage 2 extreme motherboard that mount the ICH10R chipset and i am on a raid10 setup. I have a problem with a fresh win10 install related to the irs driver that comes with installation (15.44.0.2020) and it cause a freeze in my system when there's some moderate-to-high use of hard drives. Until now i solved it with the installation of the official 11.7.4.1001 drivers+software set from intel but lately it starts to break up windows boot, and every time it's not recoverable in any ways (automatic repair, bcdboot and booterc commands in terminal ecc) so i have to format the entire system; and it starts to highly hit on my nerves. In a desperate search to fix the compatibility of win10 to my old system i landed here and want to ask you if there's a cure for that. I already tried to install your modded 11.7.4.1001 driver but the installation fails.

Help me please

yeah, thank you for the heads up on the custom image
i did not import the ca, how can i do it? sorry if i missed this point in the guide

edit: just found the ca bat in the download ^^

For those who want to using V14 or higher version of older chipset like ICH7M/R-ICH10
Please read this link here after your have finish your installation and don't not reboot immediately
otherwise you will enter GSOD loop
https://forums.intel.com/s/question/0D50...?language=en_US
I would quote some important information

Hello Fernando,

Your guidance please ... of the three latest modded SATA drivers which lead this thread, which one would you recommend to potentially achieve the highest speed thru a Intel SATA 6 MB primary channel? [All three seem to install & operate fine for the short cycles I tested them on two of my computers as defined in my signature.]

Absent a suggested "best" for my system(s), I'll have to spend a number of hours loading & bench-marking three or more driver updates, including one or more possible 'sata RST' offerings at Intel. (I am admittedly rather ignorant in the fine points of MB controller drivers and system memory.)

Thanks for Your Help AND Merry Christmas to You & Yours!!

Zitat von Fernando im Beitrag #1064

---

@stanhere:
If your Intel SATA Controller is running in AHCI mode, you should look into the start post of >this< thread. There I have published an AHCI driver comparison test, which was done with an Intel Z68 chipset system.

---